EAW EAWPilot Bedienungsanleitung PDF herunterladen (Seite 6)

The Ethernet Connection

System Connection via Ethernet

Connection to the UX8800 for laptop control is achieved using the ethernet port on the front of

the unit. This port is congured as a standard NIC (network interface card).

1) Cable: 8 conductor CAT5e cable or better

2) Mating Connector: RJ-45 male

3) Cable Conguration: Standard for connection to network hub or switch. Crossover type for

direct connection to computers NIC (supplied with unit).

Setting The UX8800 IP Address

1) Prior to connecting to a laptop computer, it is necessary to establish an IP Address on the

UX8800 so that it is recognized within the EAWPilot software.

2) Entering into the “Utilities” menu on the UX8800 and then “IP Address” will give you access to

the feature.

3) There will be four sets of numbers available to modify. The rst three numbers should be set

to 192.168.0. The last number can be set anywhere from 001 through to 256 conforming to a

small network protocol

4) It is not necessary to set a IP address for every device in the network. As long as the computer

is able to connect to the rst unit, all subsequent units in the same network will be discovered.

Device Name

Temperature – Fahrenheit / Celsius

Mode – System or Loudspeaker Processor

Mute control on Prgrm. Load

(current, all, none)

Input – A&B Analog or Digital

C&D Analog or Digital

LCD Contrast

Humidity

Front Panel Lock

About

Units – Imperial or Metric

UTIL

IP Address

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

Keine Kommentare

EAW EAWPilot Bedienungsanleitung Seite 6